Installing a shower faucet is not a Herculean task. If you are the right tricks it is as easy as conjuring up a rabbit in the air. Here's how to install a shower faucet in 7 easy steps.

Before starting the installation Here are a few things you need to be ensured.

Check the inlet check for leaks.
Replace wall with moisture resistant drywall as a base for wall, ceiling.
Always clean glue the pipe threads and a new pipe joint compound.
Run Hot and ColdLines attached to shower mixing valve.
Plan for a trap door in the wall.

These are just a few tips, you must be careful before taking the installation. Now we will begin the installation.

First, you can connect to two types of shower. You can either use the traditional method using copper pipes, or you can opt for PEX pipes. The plastic pipes are easy to install, when compared to the copper pipes.
The next thing you need to do is switch off the water and drill aHole in the shower walls with a hole saw. It is better to plan before hand, where the installation of the shower and the faucet, and marks them with a pencil.
Now position the valve so that UP indication points to the top and then the hot and cold water pipes connected to both sides of the valve. During the welding of them take care to see that overheating does not take place. You can also weld adapter, if necessary. Secure the valve in the wall and connect the tube to raise and spout pipe inwelded adapters. When valve, without outlet, then use a brass cap, the socket that blocks are not used. Place the square in shower. This is the installation of the valve.
Next to the faucet handle, push the decorative plate into the valve and the position of the handle on cassette Screw with hexagon key.
Now to install the shower head in relation to the upper main supply line to the head after the application of Teflon tape shower. Wrap-clockwise the showerHead's pipe fillets with Teflon tape. Manually screw showerhead with adjustable wrench.
Finally, the installation of the spout, turn the faucet on copper pipe, so that set screw is facing up. Tighten the screw with hexagon key and then spout to normal position.
Last but not least, open the hot and cold water supply and check that there is no leak. Next, open the faucet to warm situation, all the air in the pipes to release prisoners.

That's it. You're done. Now you can show yourCapabilities to your wife or your neighbors.

Related posts:

1. How to install a shower faucet in 7 Easy Steps
2. How to Install a Shower Filter
3. How to install a vessel sink faucet
4. How to Install a Vessel Sink Faucet
5. Faucet Dripping? You Can Repair it Yourself